Perle S-1110HP, Hi-PoE Media Converters

* Power Over Ethernet (PSE):-
* Fully Compliant with IEEE 802.3bt Type 3 and 4 PSE
* Performs the Power Sourcing Equipment (PSE) function on 1 or 2 UTP ports for IEEE 802.3bt compliant devices.
* All models support Type 1 (PoE), Type 2 (PoE+), Type 3 (Hi-PoE) and Type 4 (Hi-PoE) PD gear

* Advanced Power Management:-
* Enable/Disable PSE power by UTP port
* Single or Dual PD signature detection
* Over-Current Protection
* PD power classification detection (Class 0)

* PD Power Reset:- Ideal for remotely resetting equipment, this configurable function performs a momentary power reset to the attached Powered Device (PD). When enabled, the media converter will, upon loss of fiber RX, turn off PSE output power supplied to the PD device for 2 seconds then turn the power back on and leave it on until such time that another fiber RX link is lost (after it was re-established). When disabled, a loss of fiber RX has no effect on PSE power to the PD device(s).

* Powered Device Support:-
* Type: 1, 2, 3, and 4 PDs
* Class: 1, 2, 3, 4, 5, 6, 7, 8 PDs
* Supports both Single-Signature and Dual-Signature PD connections

* Multiport Configurations:-
* 2 port: 1x 10/100/1000Base-T and 1x 1000Base-X fixed fiber port
* 3 port: 2x 10/100/1000Base-T and 1x 1000Base-X fixed fiber port

* Power Strain Relief strap:- Included with all models, a strain relief strap is provided to ensure a solid and secure power connection to the media converter. Ideal for areas that may be exposed to vibration.

* Auto-MDIX:- Auto-MDIX (automatic medium-dependant interface crossover) detects the signaling on the copper Ethernet interface to determine the type of cable connected (straight-through or crossover) and automatically configures the connection when enabled. The media converter can also correct for wires swapped within a pair.

* Smart Link Pass-Through:- When the Link Mode switch is placed into Smart Link Pass-Through mode, the copper Ethernet port will reflect the state of the 1000Base-X media converter port. This feature can be used whether fiber auto-negotiation is enabled or disabled.

* Duplex- Full and half duplex operation supported.
* Jumbo Packets- Transparent to jumbo packets up to 10KB.
* VLAN- Transparent to VLAN tagged packets.
* Remote Loopback- Capable of performing a loopback on the 1000Base-X fiber interface.