Perle S-1110HP-SFP-XT, Hi-PoE Media Converters

* Power Over Ethernet (PSE):-
* Fully Compliant with IEEE 802.3bt Type 3 and 4 PSE
* Performs the Power Sourcing Equipment (PSE) function on 1 or 2 UTP ports for IEEE 802.3bt compliant devices.
* All models support Type 1 (PoE), Type 2 (PoE+), Type 3 (Hi-PoE) and Type 4 (Hi-PoE) PD gear

* Advanced Power Management:-
* Enable/Disable PSE power by UTP port
* Single or Dual PD signature detection
* Over-Current Protection
* PD power classification detection (Class 0)

* PD Power Reset:-
* Ideal for remotely resetting equipment, this configurable function performs a momentary power reset to the attached Powered Device (PD). When enabled, the media converter will, upon loss of fiber RX, turn off PSE output power supplied to the PD device for 2 seconds then turn the power back on and leave it on until such time that another fiber RX link is lost (after it was re-established). When disabled, a loss of fiber RX has no effect on PSE power to the PD device(s).

* Powered Device Support:-
* Type: 1, 2, 3, and 4 PDs
* Class: 1, 2, 3, 4, 5, 6, 7, 8 PDs
* Supports both Single-Signature and Dual-Signature PD connections

* Multiport Configurations:-
* 2 port: 1x 10/100/1000Base-T and 1x SFP fiber slot
* 3 port: 1x 10/100/1000Base-T and 2x SFP fiber slots
* 4 port: 2x 10/100/1000Base-T and 2x SFP fiber slots

* Fiber Redundancy:-
* When enabled on dual fiber models, the media converter treats Fiber 1 as the primary and if the link fails, the fiber link is switched over to fiber 2 within 50ms.

* Redundant Primary Fiber:-
* If the “Fiber Redundancy” feature is also enabled, the primary fiber 1 link is continuously monitored and if is restored for at least 6 seconds, the link will be switched back from the secondary fiber 2 port to the primary fiber 1 port.

* Power Strain Relief strap:-
* Included with all models, a strain relief strap is provided to ensure a solid and secure power connection to the media converter. Ideal for areas that may be exposed to vibration.

* Duplex- Full and half duplex operation supported.
* Jumbo Packets- Transparent to jumbo packets up to 10KB.
* VLAN- Transparent to VLAN tagged packets.
* Remote Loopback- Capable of performing a loopback on the 1000Base-X fiber interface.